Its self levelling properties give a smooth, ultra fine finish which requires little to no sanding at all. This makes it the perfect option for skim coating and minor body damage. Works On

It’s a 2 part system where you mix the glaze with a hardener normally 100 parts glaze & 2 parts hardener. These fillers are normally used once you’ve pulled or re-shaped a panel and need to fill any lows that are left. They have a lot more build and are great for filling dents. Once dry, rub the glaze with P180. You can go higher if you like, but there’s really no necessity to do so. The technical data sheet for dolphin says that you should sand bare steel with P80 paper before applying glaze. After application, the glaze should turn to gel within 5-8 minutes and be ready to sand within 15-20.

\n\t\t\tDolphin Glaze

The fact it’s self-leveling also helps a lot, as you’ll not have to spend time rubbing down high edges or lines. When To Use Dolphin Glaze Dolphin Glaze is a premium finishing glaze that’s designed to eliminate pinholes and other surface imperfections prior to painting. Obviously if your workplace or colleagues expect you to rub it in a higher grit do that. It’s not worth causing a stir at work just because the technical data sheet says otherwise!

Try not to apply as much pressure to the spreader when applying the glaze, otherwise, you’ll still be left with low spots. If you pull the metal out as much as possible, use a body filler, and then glaze it’ll last forever. If you’ve got as close as possible to a metal finish, a skim of dolphin on top could be enough to finish the repair. Dolphin Glaze is multifunctional and can be applied to bare steel, aluminum, galvanized steel, original paint, Body filler & GRP.Self-leveling – Depending on how good you are at applying filler, this could be a very helpful feature. Records the default button state of the corresponding category & the status of CCPA. It works only in coordination with the primary cookie. As long as you work your way through the grits, you’ll have a smooth finish with zero imperfections. Cost

Finally, it’s pretty common for technicians to mix glaze with body filler. Doing this will make a deep-filling Bondo thinner and much easier to apply.Using a lot of glaze and little to no pressure on the spreader will also allow you to do deeper fills if needed. To prep the panel ready to accept glaze, all you need to do is rub it with paper between 80 – 180 grit. It’s up to you whether you want to remove the paint completely or apply the glaze over scuffed paint. It’s recommended to use 2% hardener with this glaze. Evercoat recommends adding a “ribbon” of hardener from edge to edge, as this works out to roughly 2%. For the initial rub it’s recommended that you use 180 paper before finishing off with 240. This is more than enough if you’ve done a light skim to fix imperfections.