Uplift loads have been increased for earthquake or wind loading with no further increase allowed. Reduce where other loads govern. Many of these products are approved for installation with Strong-Drive® SD Connector screws. Model No. Post bases do not provide adequate resistance to prevent members from rotating about the base and therefore are not recommended for non top-supported installations (such as fences or unbraced carports). This 6x6 post base requires the following fasteners for installation: (1) – 5/8” concrete anchor, (12) - 16d x 3-1/2” Common Nails or (2) – ½” Machine Bolts (Use nails OR bolts. DO NOT install nails and bolts together!)

The ABU66Z provides a 1” standoff to get your 6x6 post 1” off the ground. Not only will your project be code compliant, but it will keep your post end from sitting in standing water to prevent unwanted rotting and damage. NOTE: The correct fasteners installed in the correct position must be used to achieve published load values A slotted hole for the concrete anchor allows for adjustment so you can achieve a perfect post alignment. Available in the following matching color profiles: Charleston, Huntington, Hunter, Giles, Aspen, Horizon, Meridian, Cedar Branch, Reveal, Monroe, Misty and most other P-Series profiles.For stainless-steel fasteners, see Fastener Types and Sizes Specified for Simpson Strong-Tie Connectors. The G185 ZMAX ® galvanized finish provides a level of corrosion resistance that is acceptable for use with treated lumber and normal outdoor use. If you’re installing in a high corrosive environment, i.e. near saltwater or where exposure to chemicals may occur, it’s recommended that you use a stainless steel base like the ABU66SS Stainless Post base. ABU products may be installed with either bolts or nails (not both) to achieve table loads. ABU88Z, ABU88RZ, ABU1010Z, ABU1010RZ, and ABU1212Z/RZ may be installed with (8) 1/4" x 3" Strong-Drive® SDS Heavy-Duty Connector screws (sold separately) for the same table load.